OFFICIAL XPF MAP PREVIEW
Honeywell EEM230 Modbus Register Map
Official Modbus Monitor XPF preview for the Honeywell EEM230 power meter, with 12 representative power, energy, voltage signals.
Register preview
This public preview shows 12 representative read-oriented signals. The complete official map is available in Modbus Monitor XPF.
| Signal | Address | Type | Unit | Category |
|---|---|---|---|---|
| Urms effective voltage | 400035 | UINT16 | V | Voltage |
| Irms effective current | 400036 | UINT16 | - | Current |
| Prms effective active power | 400037 | UINT16 | kW | Power |
| WT1 total counter energy total tariff 1 | 400027 | UINT32 | kWh | Energy |
| Status protect | 400021 | UINT16 | - | Status |
| Number of supported registers | 400001 | UINT16 | - | Communication |
| Hw vers Modif | 400014 | UINT16 | - | General |
| Serial number low | 400015 | UINT32 | - | Identification |
| WT1 partial counter energy partial tariff 1 | 400029 | UINT32 | kWh | Energy |
| Qrms effective reactive power | 400038 | UINT16 | kW | Power |
| Number of supported flags | 400002 | UINT16 | - | Communication |
| Baud rate | 400003 | UINT32 | - | Communication |
Addressing note
Display address copied from the official XPF map preview. Modbus reference-number and zero-based offset conventions vary by device; verify the manufacturer manual before polling or writing.
Need the complete map?
Open the pre-built Honeywell EEM230 map in Modbus Monitor XPF for the full register set, live polling, logging, and dashboards.
Open full map in XPF